MoleculeSensei
EN

Electrostatic potential maps

Charge distribution on a surface

An electrostatic potential (ESP) map colors a molecule’s electron-density surface by the electrical potential at each point. By the usual convention, red marks electron-rich (negative) regions and blue marks electron-poor (positive) regions.

Updated 3–5 min readFree 3D model, no sign-upSources

Show

Appearance

MoleculeSensei

Water. Drag to rotate; click the model, then scroll or use + and − to zoom; click an atom to identify it.

Idealised model: VSEPR angles and bond lengths estimated from covalent radii.

Key points

  • ESP maps are calculated, not photographed.
  • Colors are relative unless the scale is fixed and stated.
  • Red regions attract electrophiles; blue regions attract nucleophiles.
  • The surface represents electron density, not a hard boundary.

What the map shows

First a surface of constant electron density is calculated, roughly the molecule’s outer boundary. Then the electrostatic potential, the energy a positive test charge would feel at each point, is computed and shown as color.

Negative potential means the test charge would be attracted, usually near lone pairs and π electrons. Positive potential means it would be repelled, usually near electron-poor hydrogen atoms or cations.

Reading common examples

In water, the region around oxygen is red and the hydrogens are blue, matching the bent, polar molecule. Hydrogen fluoride shows an even stronger red–blue contrast between F and H.

In formaldehyde, the oxygen is red and the carbonyl carbon region is relatively blue. Benzene shows negative potential above and below the ring from its π electrons, with slightly positive hydrogens around the edge.

What ESP maps are useful for

They show where a molecule is likely to interact with charged or polar partners. Electrophiles approach red regions; nucleophiles approach blue ones.

They also visualize hydrogen bond donors (blue H) and acceptors (red lone pair regions) and help explain why molecules align in crystals.

Read the color scale

Many programs scale colors from the most negative to the most positive value in each molecule. Two maps drawn on different scales cannot be compared by color alone.

When comparing molecules, use a fixed scale and state its limits. A blue region on a neutral molecule can still have a small potential.

Limits and misconceptions

ESP maps depend on the calculation method and the chosen density surface. They show potential, not atomic charges, and they do not prove where a reaction will occur.

The 3D models on this site show atoms and bonds. An ESP surface is a separate calculated layer and is not implied by atom colors, which follow element conventions.

Using the models alongside an ESP map

Compare the geometry of water, hydrogen fluoride, formaldehyde and benzene with their expected charge distributions. Lone-pair regions on O and F correspond to red areas on typical ESP maps.

Rotating a model helps locate where an ESP surface would be positive or negative, but the model itself does not display potential.

Common questions

What does red mean on an electrostatic potential map?

By the usual convention, red marks negative potential: electron-rich regions such as lone pairs.

Are ESP maps experimental?

No. They are calculated from a model of the molecule’s electron distribution.

Can I compare colors between two maps?

Only if both use the same stated potential scale.

Why is benzene red above and below the ring?

Its six π electrons occupy orbitals above and below the plane of the ring, creating negative electrostatic potential there. This is where electrophiles approach in electrophilic aromatic substitution.